I bought my Timber Carbine in 2001 and the last three are 790 so our rifles are not far apart but both Winchester and USRA are known for out of sequence serial numbers. I believe if you check your barrel it will be a 1-20”twist but you can never say never. In the 2001 Gun Digest the standard Big bore is pictured and the Timber Rifle is again mentioned, but not pictured. Production of the Flat Band Carbine began approximately nine-months after Winchester had resumed production of the Model 94 following WWII. Ive been familiar with Big Bore 94s since their introduction. The Timber Carbine was listed but not pictured. Where is the serial number located on a Winchester Model 94 The serial number is located on the bottom of the receiver near the front. Model 1917 bolt-action and the famous M1 Garand semi-automatic rifles, Winchester also produced the Model 1897 and Model 12 slide-action shotguns, as well as the M1 Carbine. In addition to contract production of the U.S. and Allied troops in various parts of the globe. In the 2000 Gun Digest only the Black Shadow with the synthetic stock was pictured as chambered for the. Dating a Winchester Model 94 can be determined through the gun’s serial number. During both World Wars, Winchester-manufactured rifles and shotguns served U.S. At the time I believe there were only one or two posters who had micro-groove barrels on their Winchesters. The old thread linked below talks a bit about twist.īack when these rifles were new – about 2000 – 2002 we did a lot of talking about twist, meplat width, COL and the rather rare micro groove rifling.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |